This week I am showing you how easy it is to make a place card/napkin holder. By using my Cricut and Design Studio, I created my card by using the cartridge George and Basic Shapes.
After cutting your card, score so the end flaps fold inward; your design should be showing on the outside. On the rounded end, come in 1/2 inch and cut a slit. This will allow the pointed end to slide through. Slide that end in about 1/4 inch and fold the pointed flap down. You can square off the point if needed. When you put this together, just adjust with your hands so it stands up straight. I cut my slit a little too long and this caused the tip, when put through, unwanted sliding room. Once I got it lined up where it should be, I used a dab of glue to hold it down.
Now it's time to decorate!!
I wanted to keep with my theme, so I did not need much to bring it together. Once again I used the Victoria embossing folder on the card and Swiss Dot for the flower. I just love Core'dinations paper for embossing and sanding!!
I added the large flower, lace and 3 little flowers. Then I cut the tag using my oval Nestabilities and 'Betty' was cut using the cartridge Cursive 101 on my Cricut.
The month is not over yet!!..There is still more to come!!..I hope you have enjoyed seeing what the Design Team has been creating for you and remember, be entered to win the grand prize, you must complete all the Be Inspired Wednesday challenges for September, become a follower of Cuttlebug Challenge Blogspot and use Mr. Linky to post your creation!!